When a combine harvester harvests corn, it may cause serious consequences if it does not pay attention to these problems.

As an important crop, corn has been planted by a large number of farmers. In the past, due to the backwardness of technology, corn harvesting can only be done manually, which is time-consuming, labor-intensive and very underground. As the years progressed, corn combine harvesters gradually entered the field of vision.
However, when technology brings convenience, it is also accompanied by some safety hazards. When using corn combine harvesters daily, we are better off thinking about these matters, otherwise it may cause unnecessary safety accidents during harvesting.
The first thing that should be taken care of during the use of the corn harvester is to figure out the specific conditions of the harvested land in advance.
If the place to be harvested is relatively small and the distance is short, the best way is to combine the artificial and mechanical means. That is, first manually remove some of the fallen or underground corn. This can reduce the loss of corn harvesting, and can greatly increase the efficiency of the harvester.
The corn combine harvester uses precautions and trial harvesting.
When using a corn combine harvester, it is usually necessary to carry out a trial harvest, that is, to harvest only a little bit and look at the operation of the entire harvester. If the harvester is in good condition, it can be harvested formally. Then, when you try to harvest, you need to pay attention to the fact that you must use a file for harvesting during the trial harvesting. If the first gear is working properly, the high grade can be used for corn combine harvesting.
Ideas during the harvesting process
The operator should be skilled in grasping the operating lever to ensure that the height of the harvester's head is compatible with the height of the plot. Do not over-high or cause the straw to be too long, nor too low, or the soil will be in the corn. Moreover, during the operation of the entire harvester, it is not possible to remove the fault by hand, nor to touch the running component by hand. If troubleshooting is required, it must be stopped and turned off before troubleshooting.
The corn harvester is an extremely large and complex machine with a very long and complex drive chain. If one of the transmission parts is damaged, the entire harvesting unit will stop running. Therefore, in the process of using the corn combine harvester, it is necessary to strictly abide by the operating rules to avoid unnecessary safety accidents.
As a farmer, we should try not to get close to the corn combine harvester during the whole harvesting process. Don't make some adventures close to the harvester in order to distress the food. This will not only save the loss, but also cause serious personal safety accidents.