Common Troubleshooting Methods Of Ridging Film Mulching Machine

1. Ridging Film Mulching Machine Transverse wrinkles. This is due to the fact that the longitudinal pulling force of the plastic film is less than the transverse pulling force, and the forward speed is uneven.
Solution: ① reduce the Ridging Film Mulching Machine pressure of the left and right film pressing wheels; ② Increase the clamping force of the membrane roll; ③ The forward speed of the unit shall be uniform.

2. Ridging Film Mulching Machine Longitudinal wrinkles. This is due to the fact that the longitudinal tensile force of the plastic film is greater than the transverse tensile force.
Solution: ① Increase the pressure of the left and right film pressing wheels; ② Reduce the clamping force of the membrane roll; ③ Reduce the forward speed of the unit appropriately.

3. Ridging Film Mulching Machine Oblique wrinkles. The reason is that the unit fails to drive in a straight line during traction, or the pressure of the left and right film pressing wheels is inconsistent.
Solution: ① improve the operation technology level to make the unit move in a straight line; ② Adjust the two film pressing wheels to make their pressure uniform.

4. The Ridging Film Mulching Machine geomembrane is skewed. It is caused by the failure of the unit to drive in a straight line, or the incorrect installation of the membrane roll, or the uneven winding of the membrane roll itself.
Solution: align the membrane roll to the border surface again and make it perpendicular to the forward direction of the unit; The unit shall drive at a constant speed and in a straight line; Check the film roll and replace it if necessary.

5. The film pressing wheel cannot press the film. This is caused by the improper driving of the unit, the mismatch between the width of the plastic film and the border surface, and the poor winding quality of the plastic film itself, which should be solved according to the specific situation.

6. Curling and breakage on both sides after Ridging Film Mulching Machine laying. In case of curling, increase the pressure of the film pressing wheel, reduce the deflection angle of the cover shovel, and adjust the distance between the cover shovel and the film. In case of film breaking, the pressure of the two Ridging Film Mulching Machine film pressing wheels shall be reduced and the ground preparation quality shall be checked.