Installation And Debugging Method Of Farm Corn Combine Harvester

The use efficiency of the farm corn combine harvester header is higher, and the cost is relatively small, so it is more widely used. So what is the installation and debugging method of the corn harvester? Next, let's give you a popular science:

When the farm corn combine harvester is working stably, the horizontal shape should be maintained. If the temperature in the corn dryer is too low, the distance between the slag and the fan can be moved at will to achieve the effect. The embryo is dented, it is easy to pinch in with nails, and the nails have wet marks. The excessive tension of the miniature farm corn combine harvester increases the additional force on the shaft and the bearing, which is easy to cause the shaft journal to bend and the chain link to break.

Check whether the bearings of each part of the farm corn combine harvester and the high-speed rotating parts on the shaft (such as the stem cutting device, the intermediate shaft) are installed properly. 17%-19%: The color of the grains is fresh, there is a noise when teeth are bitten, and the teeth are not shaken.

Insufficient compression force of the engine cylinder of the farm corn combine harvester, poor spray from the fuel injection nozzle, incorrect fuel supply advance angle, clogged air filter and poor lubrication all increase fuel consumption. Remove the filter and clean it, and install the clean filter with new hydraulic oil. Properly adjust the mixed-type straw feeder, chain-type auxiliary feeding device, and finger-type auxiliary feeding device to improve the fluency of feeding the lodging corn.

The lubrication point of the farm corn combine harvester should be filled with butter once every shift (10 hours of operation). When filling butter with butter, you must add enough butter. If it cannot be filled, you can turn the lubrication part and add again until it is full. When turning at the end of the field, the header should be raised. Only the forward speed of the farm corn combine harvester can be reduced. The engine speed cannot be reduced, otherwise the threshing loss will increase.