Common Faults Of Planter And Troubleshooting Methods

Seeding device does not seed
The main reason is that the transmission gear is not meshed, or the square hole of the seeding shaft and seeding gear is worn and should be adjusted, repaired or replaced.

Individual seeder does not work
The reason is that the seed scaffold or the seeder opening in the individual seed box is clogged with debris and should be replaced with clean seeds; the connecting pin of the seeding shaft and the individual seeding sheave is broken and the pin should be replaced; The card is not pulled apart, it should be pulled apart.

Seed metering device, but there is no seed in the individual seed groove
The reason is that the opener or the seed tube is blocked (mostly on the opener on the ground wheel). The blockage should be cleared and corresponding measures should be taken to prevent debris from falling into the opener.

Seeding ceaselessly and out of control
The reason is that the separation pin of the clutch strut falls off or the separation gap is too small, and the pin should be reinstalled and locked, or the separation gap should be adjusted.

Intermittent sowing, uneven sowing
The reason is that the transmission gear meshing gap is too large and the gear is slipping and should be adjusted; the clutch spring is too weak and the gear is slipping and the spring should be adjusted or replaced.